Home · Randapparatuur · Hotrunner Regelapparatuur · Single Slide-in Controllers

Single Slide-in Controllers

Hummel TEMPSTAR Singel Slide

 

 

 

 

 

  • Flexible slide-in technology
  • Perfectly easy to operate
  • Proven thousands of times, all over the world
  • 16-ampere power unit integrated
  • Easy replacement within seconds in case of malfunction
  • Optimal mold protection
  • Ground leakage measurement

 

Slide-in controllers:

Our SINGLE slide-in controllers allow you to fit an empty housing with just the number of slide-in modules actually needed. Empty slots can be refitted later if necessary.
The integrated 16-ampere (3.600-watt) power unit ensures fast and easy module replacement, without the need to open the housing or disconnect any cables!
Each slide-in module features a display that indicates continuously the instantaneous and setpoint values. The setpoint can be adjusted directly with the plus (+) and minus (-) buttons of the decade switch. To operate the controller, no more than four front panel buttons are required. One of them switches the controller on/off, the remaining buttons serve to access and select the various operating modes. In programming mode, the same buttons are used for parameter setting.
The alarm indicators light up only in case of error or malfunction. This allows to check the operating state of the hot runner system at a glance. Ground fault, sensor error, over- / low temperature and overcurrent are indicated separately.

ETP Plastics Hardenberg

Social Media

 

ETP Plastics op Twitter ETP Plastics op Facebook Bekijk video's op ons YouTube kanaal ETP Plastics op Google+ ETP Plastics op Instagram 

Direct Contact

Tel.: (0523) 712 402

Fax: (0848) 838 830

Email: info@etpplastics.nl

Adresgegevens:

ETP Plastics B.V.

Postbus 105
7770 AC Hardenberg 

 

zie ook: contactgegevens